If the inside of your car has grown dim through the years, then it might be time to replace your interior light bulbs. Vehicles are usually equipped with a dome light and a map light. The dome light is the large light source typically placed in the middle of the car’s ceiling. Map lights are also on the car ceiling but are mounted closer towards the driver and the front passenger. These are strategically placed to have a concentrated light beam towards the driver and the front passenger only. Replacing the light bulbs in both the dome light and the map light is simple and can be done at home.

What you will need:

  • Flathead screwdriver/interior trim removal tool
  • Replacement light bulbs
    – Consult the owner’s manual in order to purchase the correct light bulbs.
    – Replacement interior dome light bulbs are typically 10W Festoon base.
    – Replacement map light bulbs come in two types depending on the vehicle. It is either a peanut light bulb, or a Festoon base light bulb.

  • Steps to Replace the Dome Light

    Make certain that the Dome light is in the “OFF” position and not on the “DOOR” or “ON” position.

    1. Identify the dome light in your car.
    2. Find the small opening slot between the lense and plastic molding of the dome light.
    3. Insert your screwdriver or interior trim removal tool and gently wiggle the lens free. Be very careful not to break the plastic tabs which secure the lens to the dome light. Take this opportunity to clean the lens.
    4. Pop out the old light bulb, and insert the replacement, being careful not to crack or break the bulb.
    5. Test if the newly installed light bulb works by turning the dome light switch ON.
    6. Pop the lens back into place paying close attention to the plastic tabs that hold it to the dome light.

    Steps to Replace the Map Light

    1. Identify where the hinge and the plastic tabs are on your map light.
    2. Gently insert the flathead screwdriver or interior trim removal tool between the lens and the plastic molding of the map light
    3. Very carefully wiggle the map light in the direction away from the plastic tab.
    4. Once dislodged, pull the lens out along with the heat shield.
    5. If your car’s map light uses a Festoon base light bulb, pop it out using your fingers or the interior trim removal tool. But if your map light is equipped with a peanut light bulb, unscrew the bulb as you would a normal household light bulb.
    6. Test the newly installed light bulb, and return the heat shield and lens carefully.As with any repairs consult your owner’s manual for specific handling and equipment needed to avoid further damage.

      Interior lights go beyond just illuminating the inside of your car. They are also a safety feature that lets you know if you’ve left the door, or even the trunk open. It is a convenience which we all have grown accustomed to, and often take for granted. Make sure your interior lights are functioning properly because it is definitely easier replacing the interior light bulbs than feeling around your car at night looking for your keys in the dark.